SRB assay

The assay relies on the ability of SRB to bind to protein components of cells that have been fixed to tissue-culture plates by trichloroacetic acid (TCA). The cell lines were grown in RPMI 1640 medium containing 10% fetal bovine serum and 2 mM L-glutamine. For present screening experiment, cells were inoculated into 96 well microtiter plates in 100 µL at plating densities. After cell inoculation, the microtiter plates were incubated at 37°C, 5% CO2, 95% air and 100% relative humidity for 24 h prior to addition of experimental drugs. Experimental drugs were initially solubilized in dimethyl sulfoxide at 100mg/ml and diluted to 1mg/ml using water and stored frozen prior to use. At the time of drug addition, an aliquot of frozen concentrate (1mg/ml) was thawed and diluted to 100μg/ml, 200μg/ml, 400μg/ml and 800μg/ml with complete medium containing test article. Aliquots of 10µl of these different drug dilutions were added to the appropriate microtiter wells already containing 90µl of medium, resulting in the required final drug concentrations i.e.10μg/ml, 20μg/ml, 40μg/ml, 80μg/ml. After compound addition, plates were incubated at standard conditions for 48 hours and assay was terminated by the addition of cold TCA. Cells were fixed in situ by the gentle addition of 50µl of cold 30% (w/v) TCA (final concentration, 10% TCA) and incubated for 60 minutes at 4°C. The supernatant was discarded; the plates were washed five times with tap water and air dried. Sulforhodamine B (SRB) solution (50µl) at 0.4% (w/v) in 1% acetic acid was added to each of the wells, and plates were incubated for 20 minutes at room temperature. After staining, unbound dye was recovered and the residual dye was removed by washing five times with 1% acetic acid. The plates were air dried. Bound stain was subsequently eluted with 10mM trizma base, and the absorbance was read on an plate reader at a wavelength of 540nm with 690nm reference wavelength. Percent growth was calculated on a plate-by-plate basis for test wells relative to control wells. Percent Growth was expressed as the ratio of average absorbance of the test well to the average absorbance of the control wells x 100. Using the six absorbance measurements [time zero (Tz), control growth (C), and test growth in the presence of drug at the four concentration levels (Ti)], the percentage growth was calculated at each of the drug concentration levels. Percentage growth inhibition was calculated as: [Ti/C] x 100% Percentage growth inhibition, total growth inhibition TGI) and LC50 was calculated. GI50 value of ≤10 µg/ml is considered to demonstrate activity in case of pure compounds. For extracts, GI50 value ≤20 µg/ml is considered to demonstrate activity. Above three parameters were calculated only when the level of activity was observed. The values were expressed as greater or less than maximum or minimum concentration tested when the effect was not reached or exceeded.10, 11